CONTURA

DROP POINT

• Acoustical
• Drywall
• Paired
• VANTAGE POINT®
• Drop Point
• Soft Point
• Custom Options
• Profiles
• Column Collars
• Perimeter Pockets
• Product Data
• Gallery

Designing On The Edge:

• Drop Point adds dimension, mass and attention to detail when viewed from any angle. Unique designs are encouraged
• Combine with 2" CONTURA for use along the straight edges of wave ceilings.
• Extruded aluminum profiles provide a strong, crisp appearance.
• Available in colors to coordinate with any suspension system.
• Factory welded corners with 12" legs
• Fully integrated with acoustical and drywall ceiling systems

Green by Design:

• 58.2% Recycled Aluminum
  • 39.1% Pre-Consumer Content
  • 19.1% Post Consumer Content
• 2 LEED^®1 Credits - MR 4
• No Hazardous Waste
• No VOCs
• No Heavy Metals

Materials:

• Aluminum Extrusion: 6063 per ASTM B 221 and ASTM B 221 Metric
• TC-2 Hanging & T-Bar Connector Clip
• CONTURA Splice Plate with Set Screws

Fabrication:

• 6" and 8" widths x 2" high x 12' length. Custom lengths and widths are available.
• 10' standard taping fin length.
• Welded end caps and welded corners

Finishes:

• Acrylic Water Base "Wet" Paints
• Custom and Standard Powder Coats
• Specialty Powder Coats
  • ACROGUARD^®
  • Antimicrobial
  • Luminescent
  • Metallic
  • Translucent

Literature	Specification		Details
PDF	TXT | DOC | PDF		DWG | DXF | PDF
	Drop Point
	Part #	A	B
	Drop Point 6"	6"	2-3/16"
	Custom edge trim... used to create a 6" wide picture frame...

Literature	Specification		Details
PDF	TXT | DOC | PDF		DWG | DXF | PDF
	Drop Point
	Part #	A	B
	Drop Point 8"	8"	2-3/16"
	Custom edge trim... used to create a 8" wide picture frame...

Drop Point Details

DWG | DXF | PDF Out Side Corner Drop Point	DWG | DXF | PDF Inside Corner Drop Point	DWG | DXF | PDF Drywall Taping Fin
DWG | DXF | PDF TC-2 Clip Overridge Tee	DWG | DXF | PDF TC-2 Clip Flush Cut Tee	DWG | DXF | PDF Splice

1 LEED^® is a registered trademark of U.S. Green Building Council